Project - CutterPillar Pro Paper Holder
posted 04/03/11 at 01:36 PM
I created a paper holder for my new CutterPillar Pro so I wouldn't have to hold the paper down with my hand. This is a cork-backed steel ruler I got ages ago for super cheap from an overstock store. I added some of my MagCraft neodymium rare earth magnets on top to make it a magnetic ruler & voila! Instant paper holder! The magnets stick to the ruler when you pull it on and off, so they don't get lost & even though the cutter is predominantly cast aluminum, the very edge near the blade is steel & therefore, magnetic. The whole project cost me $0.00 since I already had everything & it is so handy!
Copyright © 1999-2014 It's Like This LLC. Two Peas in a Bucket is a trademark of It's Like This LLC. All Rights Reserved.