|Posted: 9/22/2013 12:40:49 AM|Hi All I am new here and have just started card making and stamping. Not into scrapbooking. I was a cake decorator but have just retired from this and have this as a new hobby.
I have a magnetic pad to use with the Ebosser and was wondering how this is used. Do you put it above the die and have the die facing down onto the card or the other way around. I did try but got an impression on the top cutting pad. Any advise would be appreciated. Thanks
|Posted: 9/22/2013 8:44:21 AM|
Not sure how to use that, But just wanted to say Hi and welcome to the board...
Check out my blog www.mycraftingdiary.blogspot.com
Loc: Central NJ
|Posted: 9/22/2013 11:56:26 AM|
I am not familiar with the Ebosser. In most cases the dies are run through cutting machine facing UP. The cutting pads do mark and after lots of use will need to be replaced.
Pea, Glorious Pea
Loc: In the land of loss...weight loss, that is. 44.8 down, about 6.2 to go! :D
|Posted: 9/22/2013 6:46:58 PM|
Thank you all. I used it with the Cherry Lynn dies and it worked great. Love how it holds it in place. Must remember not to grab the wrong mat, as they do look the same and if I am not concentrating it would cut my rubber one. Love the EBosser.