|Posted: 12/23/2012 9:32:26 AM|
I don't have the die cut not the stamp nor a square punch..what can I do??
|Posted: 12/23/2012 9:36:59 AM|
Do you have a craft knife and ruler? You could draw the box on the back and cut it out.
|Posted: 12/23/2012 10:57:32 AM|
My question: What are the exact dimensions of the outside and inside and the bottom strip??
Ancient Ancestor of Pea
Loc: Between a rock and a hard place
|Posted: 12/23/2012 10:59:16 AM|I can use my old Fiskars gray trimmer to cut an inside square and then trim a rectangle around it. It's a bit tricky to line up the square corners precisely with no over cuts (I'm a perfectionist), but it can be done.
likes shiny things
Loc: Ontario, Canada
|Posted: 12/23/2012 11:10:19 AM|
I do all my cuts with a clear ruler with a grid overlay on it, and a utility knife. I have cut Polaroid-like frames the same way. I cut a square/rectangle of cardstock, and then cut out the space in the centre. I use the grid on the ruler to line up against the edges and make sure everything is square and even.
Loc: Tucson, AZ
|Posted: 12/23/2012 11:30:35 AM|Whatever!
I cut my photo square and make a mat slight bigger and a bit of a rectangle then eye ball it and there you have it a polaroid frame.
|Posted: 12/23/2012 1:23:40 PM|I use my Cameo and adjust the size to my photo. If u don't have one. Then I would just eyeball it.
|STAMPIN' UP demonstrator! Peamail me!
Silhouette Cameo lover!!
Stuck in the Middle
|Posted: 12/23/2012 2:42:02 PM|
I know it would be after the New Year before I would get it done but I could cut a few with my Cricut and mail them to you to use as templates. They would be very easy to cut with an exacto knife and ruler.
|Posted: 12/23/2012 3:04:41 PM|
I have used all the methods mentioned above but what I also do is use Picasa to create a "polaroid" using the photo I want to use. I print it, cut it out and use it.
|Posted: 12/23/2012 3:10:34 PM|Merry67, which cartridge has a polaroid frame, I can't find it. I tried the mycutsearch.com and no luck...Thanks!!
Loc: Colorado Springs, CO
|Posted: 12/23/2012 3:38:29 PM|about a week ago this thread popped up in the forum and I listed a bunch of links to diy faux-laroids.
Stuck in the Middle
|Posted: 12/23/2012 9:53:04 PM|
Merry67, which cartridge has a polaroid frame, I can't find it. I tried the mycutsearch.com and no luck...Thanks!!
I use an svg file to cut them out with.